Can you mix cat5e and cat6

Generally the longest you should try to run an Ethernet cable is meters. Electrical signals degrade over long distances, especially when you're talking super-thin wires like the ones in Ethernet cables. The faster we push data, the more sensitive the data becomes to that degradation. Cat5e and Cat6 are the most popular cables , because they allow for fast speeds but aren't prohibitively expensive. If you're a Twitch streamer or you plan to run a lot of devices at once, a Cat6 or better can ensure that you won't have to replace your cables too soon.

In general, Cat5 has very stringent requirements on twists, etc. You can 't really join two pieces together. Some people have used couplers with some luck, but it's not a good thing to do , in general. Cable is cheap - Just head down to Home Depot and you can pick some up for practically nothing. If there is an existing twisted-pair copper or coax cable run, then you can extend your network with a pair of Ethernet extenders.

Extenders can deliver Mbps speeds over meters or about Mbps at meters. How to Extend Cat 5 Cabling Plug one of the 5-port switches into an electrical outlet near the terminus of an Ethernet cable close to its limit of meters, or feet. Insert an additional long cable into another port on the switch. Take the second switch into a room where expansion of the number of ports is desired. Can you mix Cat5E and cat6 cables? Category: technology and computing computer networking. What is cat 8 cable used for?

Will cat6 work with my router? Does it matter what kind of Ethernet cable I use? What category of Ethernet cable do I need? Is Cat 5e Gigabit? Is cat5e good enough for gigabit? Is cat5e good enough for gaming? Will cat6 improve Internet speed? Do you need cat6 for gigabit?

Both types are twisted pair cables. Cat5 enhanced cables Cat5e are able to support Gigabit Ethernet speeds. Category 6 Cat6 is a standardised cable that moves beyond 5e technology with precise interference specifications and the ability for gigabit speeds. Category 6 cable also provides a greater bandwidth of MHz for media applications, compared to MHz for the basic category 5e product.

Cat6 cables feature a higher signal-to-noise ratio than Cat5e. It was always my understanding that you could mix cat5E, cat6X, etc with no issue even on the same switch. I have been troubleshooting some random issues in an SMB network. Existing cable is cat5E patch cables owner just drilled holes in the floor and ran them through holes in the floor. In an expansion, I ran cat6 cable monoprice cable, jacks, trendnet patch panel all cat6 rated. I mentioned it to an I. T friend and she seemed to think that all the cables had to have matching rating.

Said at a prior job like 10 yrs ago they replaced cat5E with cat6. I said I didn't believe that mattered, and it was probly a futureproofing. It was also a military base so I said they probly had some kind of use or lose funding so they just did the entire thing.

Then she was like could be I know some years we were retiring like one year old computers. Synchronet is an IT service provider. Sure there is a place if your gear will handle it, or you see a future need.

This case it is just a simple unmanaged 16 port netgear prosafe switch they all link to. It is either cable setup, but in this case I think it is a malfunctioning WAP. There is no performance degradation or boost in a mix cable environment. As Neally says, it's in the longer runs where you will notice.

Pretty much what I thought. I typically don't think too much of cable length difference, but I could see the point.